7. Running
the Simulation
- From the SETUP palette, select FAULT PARAMS. A Fault Parameters
dialog box will appear as shonw in Figure 21. Click on Fault Dictionary
Toggle and Tristate Detection Toggle. Both those parameters should be on
as shown in Figure 21. Close the window. You can now save your fault dictionary
after running.
- Figure 21
- Close the TRACE window.
- Select all the inputs and outputs from the schematic menu. From the
SETUP palette menu, select TRACE.
- From the Palette menu select RUN > For Time. A dialog box
will appear as shown in Figure 22. Specify the run time as 5000
and then click on OK. After the run is complete you should see the
results in the Trace window similar to Fig 23.
Figure 22
Figure 23
click
here to go back to the Index