6. Setting
up the Test
- From the palette menu, select the SETUP menu.
- Select all the input and output ports from the schematic window.
- From the setup palette menu, select SETUP PO TESTS. You should
see the dialog box shown in Figure 18. Make sure that the Turn Detected,
Selected nets and Full are on. In the After a delay of
box enter 90
Figure 18
- Click on Setup Cycles and then Add New Cycles. An Add
Cycle Dialog box will appear as shown in Figure 19. Give the cycle name
of cycle1 and the cycle period as 100.
Figure 19
- Click on Setup Cycles again and click on the Enable test1.
A dialog box will appear as shown below in Figure 20. Click on OK.
Following this, cycle1 100 should appear in the cycle name box as
shown in Figure 18.
Figure 20
Click on OK and the SETUP PO TEST dialog box should disappear.
click
here to go back to the Index